![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-fp-6000-series/cutler-hammer-fp-6000-series_instructions-manual_4035779033.webp)
IB02602004E
For more information visit: www.eaton.com
Instructional Literature
Effective: May 2008
Page
33
Instructions for the FP-6000 Protective Relay
4.6.1.7 Selecting the "RTD Readings" Sub-menu
This menu allows the user to view the RTD temperature
readings.
Table 9. RTD Reading Sub-menu.
4.6.1.8 Selecting the “Maximum RTD” Sub-menu
This menu allows the user to view the maximum RTD
temperatures. The display format is the same as the Display 9
Sub-menu.
Table 10. Maximum Sub-menu.
The Date and Time Stamp is also recorded on the same page
with the minimum value display for each parameter occurrence.
4.6.2 View Settings
Press the “View Setting”
pushbutton to view the existing
settings in the FP-6000 program
settings. The red LED in the upper
left-hand portion of the
pushbutton area will illuminate
while you are in the View Setting
Mode. Display 10 shows the
options provided by pressing the
“View Setting” pushbutton. Note
that the possible selections are
only viewable three at a time.
Going in to the “View Settings Mode” has no effect on the
settings. The user cannot change the settings in this mode, this
mode is for viewing the settings only.
Display 10. View Settings “Main”.
Select one of the Setting Main sub-menus using the
Up/Down
pushbuttons and press the
Enter
pushbutton. This will provide
any of the monitor screens shown in the following Display. The
data in the second column is an example value (please see
Section 5 for all available settings of the FP-6000). Use the
Previous
pushbutton to return to the “Setting Main” screen to
select another category of data screen. Note that the user can
only view the settings three lines at a time on the display. Use
the
Up/Down
pushbuttons to scroll through all of these settings.
WHERE <VARIABLE> (VARIABLE) =
<RTD1>
(RTD1)
<RTD2>
(RTD2)
<RTD3>
(RTD3)
<RTD4>
(RTD4)
<RTD5>
(RTD5)
<RTD6>
(RTD6)
<RTD7>
(RTD7)
<RTD8>
(RTD8)
<RTD9>
(RTD9)
<RTD10>
(RTD10)
<RTD11>
(RTD11)
WHERE <VARIABLE> (VARIABLE) =
<RTD1>
(RTD1)
<RTD2>
(RTD2)
<RTD3>
(RTD3)
<RTD4>
(RTD4)
<RTD5>
(RTD5)
<RTD6>
(RTD6)
<RTD7>
(RTD7)
<RTD8>
(RTD8)
<RTD9>
(RTD9)
<RTD10>
(RTD10)
<RTD11>
(RTD11)
Setting Main
System Config
Protection
Breaker Curve
System Alarms
Logging
Input CFG
Output Config
LED Config
Programmable Logic
Control Logic
Communications
Setting Main
> System Config
Protection
Breaker Curve