![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-fp-6000-series/cutler-hammer-fp-6000-series_instructions-manual_4035779019.webp)
IB02602004E
For more information visit: www.eaton.com
Instructional Literature
Effective: May 2008
Page
19
Instructions for the FP-6000 Protective Relay
Table 5. Table of Specifications (continued).
IPONI COMMUNICATIONS:
TB3 J1
Baud Rate
9600 Fixed
Max. Distance
10,000 ft.
Protocol
INCOM Slave
Media
Shielded Twisted Pair - CH IMPCABLE; BELDEN 9463, 3072F
Signal Lines
J1-1, J1-2 Polarity Not Needed
Shield
J1-3 Filter Referenced to Chassis
dc Input Impedance
~2 ohms
ac Input Impedance @ 100 kHz
> 30k/100 ohms Unterminated/Terminated - Switch
ACCESSORY BUS:
TB3 J2 - FUTURE INTERFACE
Baud Rate
9600 Fixed
Max. distance
10,000 Ft. (254 m)
Protocol
INCOM
Media
Shielded Twisted Pair - CH IMPCABLE: Belden 9463, 3072F
Signal lines
J2-1, 2-2 Polarity Not Needed
Shield
J2-3 Filter Referenced to Chassis
dc input impedance
~2 ohms
ac Input impedance @ 100 kHz
> 100 ohms (Permanent Termination Resistor)
ZONE INTERLOCK:
TB3 J3
Zone Out
J3-1 Open Collector Output ~ 4.5 V to Common
Zone In
J3-4, Approximately 300K ohms Input Impedance
Zone Common
J3-2, 3-5 Internally Connected
Zone Shield
J3-3 Referenced Direct to Chassis – NOT REQUIRED
Cable
14-18 AWG Twisted Pair <250' Between 1
st
and Last Unit
RS-232:
FRONT TEMPORARY PROGRAMMING MONITOR PORT POWERPORT CONNECTION
Baud Rate
38.4 kB, 19.2 kB, 9.6 kB
Connector
Standard 9-Pin D Subminiature, DCE Connection P2, 3, 5
Protocol
INCOM ASCII Slave
Cable
Shielded & Restricted to < 3 m (9.8 ft.) in Length
METERING ACCURACY:
Input Signal Frequency Necessary for Accurate Operation
60 Hz Nominal, 57-63 Hz (5%)
50 Hz Nominal, 47-53 Hz (5%)
Frequency Measurement Accuracy
+0.02 Hz
Clock Accuracy
Free R 1 minute/month @ 25°C (77°F).
Automatically Updated by PowerNet Host when Present