![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-fp-6000-series/cutler-hammer-fp-6000-series_instructions-manual_4035779035.webp)
IB02602004E
For more information visit: www.eaton.com
Instructional Literature
Effective: May 2008
Page
35
Instructions for the FP-6000 Protective Relay
4.6.2.1 Protection
Display 16. View Settings.
“Protection” Display:
Note:
The number of setting groups that are displayed is programmable in the Configuration Settings as “# Set Grps.” The default # of setting groups
is 1, so this “display” will normally only show “Setting Group 1.” If “# Set Grps” is set to “4,” then all four setting groups will be displayed as shown
above. All four setting group’s sub-menus display the same settings, therefore only one example setting group is shown here.
“Phase Overcurrent” Display:
Protection
S
etting Group 1
S
etting Group
2
S
etting Group 3
S
etting Group 4
Setting Group 1
Phase Overcurrent
I
X
Measured OC
IR Residual OC
Unbalance
S
ettings
Main
V
Protection
A
ux
V
Protection
Neutral
V
Protection
Freq. Protection
Power Protection
Breaker Failure
Power Factor
Zone Interlocking
2
5
S
ync Check
3
2V
V
ar Trip
Thermal Protection
A
larms
Thermal
A
larms
Phase Overcurrent
51P PH TOC Curve
51P PH TOC
S
etting
51P
2
PH TOC Curve
51P
2
PH TOC
S
etting
50P-1 PH IOC 1
50P-
2
PH IOC
2
51P PH TOC Curve
S
hape:
MOD
Reset:
Calc
Direction:
Both
51P PH TOC Setting
Pickup (pu):
1.00
Time Mult:
1.00
50P-1 PH IOC 1
Pickup (pu):
2
.00
Delay (c):
0
Direction:
Both
51P2 PH TOC Curve
S
hape:
MOD
Reset:
Calc
Direction:
Both
51P2 PH TOC Setting
Pickup (pu):
1.00
Time Mult:
1.00
V
Restraint:
Disable
50P-2 PH IOC 2
Pickup (pu):
2
.00
Delay (c):
0
Direction:
Both