![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-fp-6000-series/cutler-hammer-fp-6000-series_instructions-manual_4035779193.webp)
IB02602004E
For more information visit: www.eaton.com
Instructional Literature
Effective: May 2008
Page
193
Instructions for the FP-6000 Protective Relay
Table 60. Event General Cause Table.
Every pickup and dropout of an enabled protection function can
be logged in the Event log. Each class of pickups must be
programmed to be logged (see Section 5). Observing pickups in
the Event log can show if a current or voltage transient is causing
a pickup. Most values given with each log can be accessed by
selecting the line immediately below the Cause and pressing
Enter. The information given is a series of status flags that show
the state of that status at the time of the event. Table 61 shows all
the possible event causes that are a pickup or a dropout of a
protective function.
CAUSE
CAUSE DESCRIPTION
VALUE GIVEN
PwrOn
The FP-6000 is powered on.
No value associated with this cause.
PwrOff
The FP-6000 is powered off.
No value associated with this cause.
FltPwrOp
Transition to Fault Powered Operation.
No value associated with this cause.
SetChange
The program settings are changed and saved.
The Setpoint Sequence number.
PRSetGrpCh
The protection active setting group is changed.
The new active setting group number (#1 - #4).
SetRTC
The real time clock is set to a new date/time.
No value associated with this cause.
Trig Wfm Capt
The trigger for a waveform capture is activated.
The event that has caused the trigger – dV/dI, Logic, PB, Comm.
Rst Trip/Alm
A reset of the trip or alarm is performed.
No value associated with this cause.
Reset Energy
The energy values are reset.
No value associated with this cause.
RstCurPKDmd
The current peak demand values are reset.
No value associated with this cause.
RstPwrPKDmd
The power peak demand values are reset.
No value associated with this cause.
RstMinMax
The min and max values are reset.
No value associated with this cause.
RstHistLog
The history log has been reset.
No value associated with this cause.
ClrDataLogger
The data logger saved data is cleared.
No value associated with this cause.
Default Set
The setpoints are returned to the default settings.
The Setpoint Sequence number.
RstARLock
Reset Autoreclose Lockout Mode.
No value associated with this cause.
ClrWfmLock
Clear Waveform Buffer Lock.
No value associated with this cause.