a. Insert the LED panel into the slot in the chassis.
b. Secure the LED panel with the screws.
2.
Insert the control panel board into the slot in the chassis and align the two screw holes on the
control panel board with the corresponding holes on the chassis.
3.
Secure the control panel board with the screws.
4.
Connect all the cables to the control panel board.
Next steps
Follow the procedure listed in
After working inside your system
.
Power interposer board
The power interposer board is present only in systems that support redundant power supply units.
Removing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: The power interposer board is present only in systems that support redundant power
supplies.
1.
Ensure that you follow the
Safety instructions
.
2.
Keep the Phillips #2 screwdriver ready.
3.
Follow the procedure listed in
Before working inside your system
.
4.
Remove the power supply units from the system.
Steps
1.
Disconnect the power distribution cables from the system board.
2.
Remove the two screws securing the power interposer board (PIB) to the chassis.
3.
Holding the PIB, lift it slightly to disengage it from the screw holes.
4.
Slide the PIB toward the back of the chassis and lift it out of the chassis.
124
Содержание PowerEdge R330
Страница 1: ...Dell PowerEdge R330 Owner s Manual Regulatory Model E34S Series Regulatory Type E34S001 ...
Страница 22: ...22 ...
