Figure 37. Removing and installing the SD vFlash card
1.
SD vFlash card
2. SD vFlash card slot
3.
Install a replacement SD vFlash card by inserting the contact-pin end of the SD vFlash card into the
SD vFlash card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the SD vFlash card.
4.
Press the SD vFlash card inward to lock it into the SD vFlash card slot.
Removing the optional iDRAC port card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you follow the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Keep the Phillips #2 screwdriver ready.
4.
If connected, disconnect the network cable from the iDRAC port card.
5.
Remove the cooling shroud.
Steps
1.
Loosen the screw securing the iDRAC port card holder to the system board.
2.
Pull the iDRAC port card to disengage it from the iDRAC port card connector on the system board,
and remove the card from the chassis.
92
Содержание PowerEdge R330
Страница 1: ...Dell PowerEdge R330 Owner s Manual Regulatory Model E34S Series Regulatory Type E34S001 ...
Страница 22: ...22 ...