1.
Ensure that you follow the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
If installed, remove the optical drive blank by pressing the blue release tab at the back of the blank
and pushing the blank out of the system.
Steps
1.
Align the optical drive with the optical drive slot on the front of the chassis.
2.
Slide the optical drive into the slot until the latch snaps into place.
3.
Connect the power and data cables to the back of the optical drive.
4.
Route the power and data cables through the cable routing latch of the system.
5.
Connect the power and data cables to the connectors on the system board.
Next steps
Follow the procedure listed in
After working inside your system
.
Cooling fans
Depending on your system configuration, your system can support up to four cooling fans.
NOTE: Hot swappable removal or installation of the fans is not supported.
NOTE: Each fan is listed in the management software of the system, referenced by the respective
fan number. If there is a problem with a particular fan, you can easily identify and replace the proper
fan by noting down the fan numbers provided on the cooling fans.
The following table shows the number of fans required for different system configurations:
Table 13. Number of fans based on system configuration
System configuration
Number of fans
Systems with four 3.5-inch hard drives or four 2.5-inch hard drives with adapter
3
Systems with four 3.5-inch hard drives or four 2.5-inch hard drives with adapter
with PCIe riser card
4
Systems with eight 2.5-inch hard drives
4
NOTE: Ensure that you install a cooling fan blank in an empty cooling fan bracket.
Removing the cooling fan blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: The procedure for removing each cooling fan blank is identical.
1.
Ensure that you follow the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
78
Содержание PowerEdge R330
Страница 1: ...Dell PowerEdge R330 Owner s Manual Regulatory Model E34S Series Regulatory Type E34S001 ...
Страница 22: ...22 ...
