Dell PowerConnect W Airwave 7.1, Руководство пользователя

Страница: 130 / 334

130 | Discovering, Adding, and Managing Devices Dell PowerConnect W AirWave 7.1 | User Guide
5. Define and confirm the Community String to be used during scanning. In this section, the community string
used can be either read-only or read/write , as AWMS only uses it for discovering APs. To bring APs under
management, AWMS uses the credentials supplied in the Device Setup > SNMP page.
6. Click Add . The Device Setup > Discover page displays the new scan credential or credentials just created or
edited.
7. Repeat these steps to add as many credentials as you require.
8. Once scan networks and scan credentials are defined, combine them by creating scan sets using the next
procedure titled “Defining a SNMP/HTTP Scan Set” on page 130 .
Defining a SNMP/HTTP Scan Set
Once you have defined at least one network and one scan credential, you can create a scan set that combines the
two for device discovery. Perform these steps to create a scan set.
1. Locate the Scan Set area at the top of the Device Setup > Discover page. Figure 75 , shown previously,
illustrates this page. The Scan Set pane is illustrated in Figure 78 .
Figure 78 Device Setup > Discover > Scan Sets Section Illustration
2. Click Add New Scan Set , and the Scan Set section displays. Below the Scan Set section, the Networks and
Credentials sections display all scan components configured so far. If you wish to create a new network, or
new scanning credentials, you can click Add in either of these fields to create new components prior to
creating a scan set.
Figure 79 illustrates the Add New Scan Set page.
Note: AWMS automatically appends the type of scan (SNMP or HTTP) to the Label.