Dell PowerConnect W Airwave 7.1, Руководство пользователя

Страница: 103 / 334

Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 103
8. To configure radio settings for Cisco VxWorks devices in the group, locate the Groups > VxWorks section
and adjust these settings as required. Table 65 describes the settings and default values of this page.
9. To configure settings specific to the Proxim AP-600, AP-700, AP-2000, AP-4000; Avaya AP-3/4/5/6//7/8, and
ProCurve 520WL, locate the appropriate section of Groups > Radio page and define the required fields.
Table 66 describes the settings and default values.
Table 64 Enterasys AP3000 and Enterasys AP4102 > Proprietary Settings Fields and Default Values
Setting Default Description
802.11a Multicast Data
Rate
6 Mbps Drop-down menu that specifies the a radio multicast data rate.
802.11b/g Multicast Data
Rate
5.5 Mbps Drop-down menu that specifies the b/g multicast data rate.
Rogue Scanning Enabled If enabled AP 3000s and 4102s in the group with firmware 3.1.20 or newer will
passively scan for rogue access points at the specified interval for the specified
amount of time. This rogue scan will not break users' association to the network.
Rogue Scan Interval (30-
10080 min)
720 Specifies the time, in minutes, between rogue scans.
Rogue Scan Duration
(200-1000 msec)
350 Specifies the amount of time, in milliseconds, the AP listens to rogues before returning
to normal operation.
Table 65 Groups > VxWorks Proprietary Settings Fields and Default Values
Setting Default Description
Use Aironet
Extensions
Yes When enabled, this option allows Cisco devices to provide functionality not supported by
802.11 IEEE standards, including the following:

Load balancing—Allows the access point to direct Aironet clients to the optimum access
point.

Message Integrity Check (MIC)—Protects against bit-flip attacks.

Temporal Key Integrity Protocol (TKIP)—Key hashing algorithm that protects against IV
attacks.
Lost Ethernet
Action
Repeater
Mode
Pull-down menu that specifies the action to take when the Lost Ethernet Timeout threshold is
exceeded:

No Action—No action taken by the AP.

Repeater Mode—The AP converts to a repeater, disassociating all its clients while the
backbone is unavailable. If the AP can communicate with another root AP on the same
SSID, its clients will be able to re-associate and connect to the backbone. If the AP
cannot communicate with another root AP, clients are not allowed to re-associate.

Disable Radio—The AP disassociates its clients and disables the radio until it can
establish communication with the backbone.

Restrict SSID—The AP disassociates all clients and then allows clients to re-associate
with current SSID.
Lost Ethernet
Timeout
(1-1000 secs)
2 Specifies the time (in seconds) the AP waits prior to taking action when its backbone
connectivity is down. Actions are defined in the Lost Ethernet Action field.
Upgrade Radio
Firmware When
AP Firmware Is
Upgraded
Yes If enabled, this setting mandates that the radio firmware be upgraded to a firmware version
compatible with the current version of AP firmware.