Dell IDRAC6, Руководство пользователя

Страница: 116 / 472

116
Configuring iDRAC6 Enterprise Using the Web Interface
Updating iDRAC6 Firmware
NOTE:
If iDRAC6 firmware becomes corrupted, as could occur if iDRAC6 firmware
update is interrupted before it completes, you can recover iDRAC6 using the CMC.
See your
CMC Firmware User Guide
for instructions.
NOTE:
The firmware update, by default, retains the current iDRAC6 settings.
During the update process, you have the option to reset iDRAC6 configuration to the
factory defaults. If you set the configuration to the factory defaults, external
network access will be disabled when the update completes. You must enable and
configure the network using iDRAC6 Configuration Utility or the CMC Web interface.
1
Start iDRAC6 Web interface.
2
Click System
→
Remote Access
→
iDRAC6 , and then click the Update tab.
Timeout The Telnet idle timeout, in seconds. Timeout range is 60 to
10800 seconds. Enter 0 seconds to disable the Timeout
feature. The default is
1800 .
Port Number The port on which iDRAC6 listens for a Telnet connection.
The default is
23 .
Table 5-30. SNMP Agent
Setting Description
Enabled Enables or disables email alerts.
SNMP Community
Name The name of the community that contains the IP address
for the SNMP Alert destination. The Community Name
may be up to 31 non-blank characters in length. Default=
public.
Table 5-31. Automated System Recovery Agent
Setting Description
Enabled Enables the Automated System Recovery Agent.
Table 5-29. Telnet Settings (continued)
Setting Description