Club Car 1996 DS Golf Car Gasoline, Руководство по обслуживанию

Страница: 57 / 544

Page 6-11
G
E
6
REMOVING THE PARK BRAKE ASSEMBLY
1. To remove the park brake rod and pawl assembly (9 through 13 and 32), remove the push-on nut (11)
and disconnect the ball joint sleeve (13) from the park brake pedal (1). Remove the ball joint sleeve (13)
from the rod and pawl assembly (Figure 6-13). See NOTE below.
2. To remove the park brake pedal (1), remove the push-on retainer nut (4), disconnect the torsion spring
(20) (Figure 6-15) and slide the pedal off of the shaft. See NOTE below.
3. Inspect all parts for wear or damage and replace as necessary.
INSTALLING THE PARK BRAKE ASSEMBLY - EARLY 1995 VEHICLES
1. From the bottom side of the floorboard, insert the park brake rod (9) through the brake pedal assembly
opening as shown in Figure 6-15. Then install the park brake pawl (32) onto the shaft on the brake
pedal assembly weldment (6) and also the park brake rod (9) into the park brake pawl (Figure 6-15).
2. Install the push nut (11) onto the park brake pawl shaft (Figure 6-15).
3. Install the spacer (21) and torsion spring (20) on the park brake pedal shaft on the brake pedal weld-
ment (Figure 6-15).
4. Install the two bushings (2) in the park brake pedal and position the park brake pedal on the shaft on
the brake pedal assembly weldment (Figure 6-15). Then attach the ends of the spring to the park brake
pedal and to the brake pedal weldment as shown (See Figure 6-16, Page 6-12).
5. Install the push nut (4) on the park brake pedal shaft (Figure 6-15).
6. Connect park brake rod (9) ball joint to the ball stud on the park brake pedal assembly (Figure 6-15).
• BRAKE PEDAL FREE PLAY IS THE DISTANCE THE BRAKE PEDAL CAN BE DEPRESSED
BEFORE THE BRAKE ACTUATOR ARM MOVES.
• A NEW PUSH-ON NUT (11) (FIGURE 6-15) MUST BE USED WHEN REASSEMBLING THE PARK
BRAKE.
• A NEW PUSH-ON NUT (4) (Figure 6-15) MUST BE USED WHEN REASSEMBLING THE PARK
BRAKE.
FIGURE 6-14 FIGURE 6-15
NOTE
NOTE
NOTE
STOP
1
2
4
2
20
21
6
13
12
9
10
11
32