Club Car 1996 DS Golf Car Gasoline, Руководство по обслуживанию

Страница: 173 / 544

Page 12-37
G
12
6. Reinstall the access panel (Figure 12-37, Page 12-26).
7. Install the seat on the rear body.
BELT ADJUSTMENTS
Belt tension should be checked periodically. If the starter/generator slips when starter motor operates, adjust
belt to correct tension.
Belt Tension Adjustment
1. Remove the access panel from the rear body (Figure 12-37, Page 12-26).
2. Make sure the two pivoting screws (5) on the mounting bracket are finger tight. The adjustment screw
(11) and nut (12) are to be finger tight also (Figure 12-50).
3. Push the starter down so it is at the lowest part of its adjustment travel. With the starter belt fully in
place around the drive clutch pulley (this pulley is the one closest the crankcase cover on the engine),
install the starter belt (3) around the pulley (10) on the end of the starter/generator (1). Place the ten-
sion tool (13) (Club Car Part No. 1016867) between the starter/generator and the starter/generator
mounting bracket (2) so that the tension tool will lift up the starter/generator.
4. Install a standard 1/2 inch (12.7 millimeter) drive torque wrench (14) into the tension tool (13). Through
the access opening in the rear body, position the wrench tension tool as shown (Figure 12-50). Pull up
on the wrench and tension tool until 70 ft. lbs. (95 N-m) of torque has been applied for a new belt. Apply
only 40 ft. lbs. (54 N-m) for a previously used belt.
5. Tighten the adjustment nut (12) to 12 ft. lbs. (16 N-m) of torque. Tighten the two pivot screws (5) and
torque nuts (7) to 21-25 ft. lbs. (28.4/34 N-m) (Figure 12-50) (See CAUTION below and NOTE at the
top of page 12-38).
FIGURE 12-50
• REMOVE TENSION TOOL BEFORE STARTING ENGINE.
1
4
9
12
7
6
5
TYPICAL
2 PLACES
10
2
13
14
11
3
CAUTION