Club Car 1996 DS Golf Car Gasoline, Руководство по обслуживанию

Страница: 120 / 544

Page 9-10
9
E
G
Removing the Transaxle - DS Electric, Continued:
12. Carefully lift each end of the transaxle off of its positioning pin (on the leaf spring) and slide the trans-
axle to the rear and out of the vehicle.
13. Drain the lubricant from the transaxle as instructed on Page 9-1.
14. Remove the axle shaft as instructed on Page 9-2.
15. If removal of the brake assemblies is required, see Section 7 of this manual.
DISASSEMBLY, INSPECTION, AND ASSEMBLY OF THE TRANSAXLE
DISASSEMBLY AND INSPECTION OF THE TRANSAXLE
1. To detach the axle tubes (16 and 39) (Figure 9-1, Page 9-1) from the transaxle housing, remove the
bolts and lock washers (8 and 9) (Figure 9-1). See NOTE below.
2. Remove the ten bolts (26) (Figure 9-1) that hold the housing together.
3. Pull the halves of the housing apart. If necessary, tap lightly with a rubber mallet on the spline of the
input pinion.
4. Remove the input pinion gear by pulling it out while rocking the intermediate gear assembly. Lift out the
intermediate gear assembly and the differential cage gear unit simultaneously (Figure 9-18, Page 9-9).
• SHIMS ARE LOCATED BETWEEN THE AXLE TUBE AND DIFFERENTIAL CAGE BEARING. CARE
SHOULD BE USED TO AVOID DAMAGING THE SHIMS. IF THE SHIMS ARE REMOVED, SET
THEM ASIDE FOR REINSTALLATION.
• TO PREVENT DAMAGE TO THE MATING SEAL SURFACES OF THE HOUSING, USE CARE
WHEN SEPARATING THE HALVES.
FIGURE 9-19 FIGURE 9-20
• TO AVOID DAMAGING GEARS, USE EXTREME CARE WHEN HANDLING THEM.
NOTE
CAUTION
ARBOR
PRESS RAM
REMOVE KEY
CAUTION