Club Car 1996 DS Golf Car Gasoline, Руководство по обслуживанию

Страница: 428 / 544

Page 21-36
21A
E
Test Procedure 15 - On-board Computer Red and Yellow Wire Fuses, Continued:
• For vehicles with serial number A 9615-4942279 and later:
The fuse that was on the yellow wire has been incorporated into the circuitry of the on-board computer.
The fuse on the red wire is now located approximately six inches (15 cm) from the main solenoid and is
in a yellow rubber housing. This fuse can be easily removed from the rubber housing and tested with a
continuity tester or with a multimeter set to ohms (
Ω
). To test the fuse, place the black (-) probe on one
end of the fuse and place the red (+) probe on the other end (Figure 21-42, Page 21-35). The reading
should be continuity. If the reading is incorrect, replace the fuse.
Test Procedure 16 - Voltage from the Forward and Reverse Switch to the Z6 (White
Wire) and Z7 (Blue Wire) Positions on the Z Plug
1. Turn the key switch to OFF and place the forward and reverse switch in NEUTRAL. Leave the batteries
connected and disconnect the Z plug from the controller.
2. Place the black (-) probe of a multimeter, set to Volts DC, on the negative (-) post of battery No. 6 and
place the red (+) probe in the Z6 (white wire) connector position in the Z plug (Figure 21-43). Turn the
key switch to ON and place the forward and reverse rocker switch in forward; the reading should be Full
Battery Voltage. If the reading is zero volts, check the forward and reverse rocker switch and wiring
(See Test Procedures 17 and 18).
FIGURE 21-43 FIGURE 21-44
FIGURE 21-45 FIGURE 21-46
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
BATTERY BANK
-
+
+
-
-
-
+
+
2
3
4
6
5
Z8 Z9 Z10 Z11 Z12 Z13
Z1 Z2 Z3 Z4 Z5 Z6
Z7
Z14
PLACE RED PROBE INTO
THE Z6 POSITION ON THE Z PLUG
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
BATTERY BANK
-
+
+
-
-
-
+
+
2
3
4
6
5
Z8 Z9 Z10 Z11 Z12 Z13
Z1 Z2 Z3 Z4 Z5 Z6 Z7
Z14
PLACE RED PROBE INTO
THE Z7 POSITION ON THE Z PLUG
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
FORWARD AND REVERSE
ROCKER SWITCH
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
FORWARD AND REVERSE
ROCKER SWITCH