Club Car 1996 DS Golf Car Gasoline, Руководство по обслуживанию

Страница: 429 / 544

Page 21-37
E
21A
3. Place the black (-) probe of a multimeter, set to Volts DC, on the negative (-) post of battery No. 6 and
place the red (+) probe in the Z7 (blue wire) connector position in the Z plug (Figure 21-44). Turn the
key switch to ON and place the forward and reverse rocker switch in reverse; the reading should be Full
Battery Voltage. If the reading is zero volts, check the forward and reverse rocker switch and wiring.
(See Test Procedures 17 and 18).
Test Procedure 17 - Forward and Reverse Rocker Switch Continuity
1. Turn the key switch to OFF and place the forward and reverse switch in NEUTRAL. Disconnect the bat-
teries and leave the Z plug connected to the controller.
2. Remove the three screws that attach the forward and reverse rocker switch to the vehicle body.
3. Disconnect the 18 gauge red/white, blue, and white wires from the rocker switch terminals. Do not dis-
connect the black and orange wires.
4. Place the black (-) probe of a multimeter, set to ohms (
Ω
), on the center terminal of the rocker switch
(red/white wire position) and place the red (+) probe on the terminal oriented toward the passenger
side of the vehicle (white wire position). With the forward and reverse switch in Neutral, the reading
should be no continuity. Place the rocker switch in Forward; the reading should be continuity. Place the
rocker switch in Reverse; the reading should be no continuity. If the readings are incorrect, replace the
rocker switch (Figure 21-45, Page 21-35).
5. Place the black (-) probe of a multimeter, set to ohms (
Ω
), on the center terminal of the rocker switch
(red/white wire position) and place the red (+) probe on the terminal oriented toward the driver side of
the vehicle (blue wire position). With the forward and reverse switch in Neutral, the reading should be
no continuity. Place the rocker switch in Forward; the reading should be no continuity. Place the rocker
switch in Reverse; the reading should be continuity. If the readings are incorrect, replace the rocker
switch (Figure 21-46).
Test Procedure 18 - Forward and Reverse Rocker Switch (Z6 White Wire and Z7 Blue
Wire) Continuity
1. Turn the key switch to OFF and place the forward and reverse switch in NEUTRAL. Disconnect the bat-
teries and disconnect the Z plug from the controller.
2. Remove the three screws that attach the forward and reverse rocker switch to the vehicle body.
3. Disconnect the 18 gauge red/white, blue, and white wires from the rocker switch terminals. Do not dis-
connect the black and orange wires.
4. Place the black (-) probe of a multimeter, set to ohms (
Ω
), on the red/white wire terminal end (that was
removed from the rocker switch) and place the red (+) probe on the small post of the main solenoid
(with red/white, blue, and red wires attached). The reading should be continuity. If the reading is incor-
rect, repair or replace the red/white wire (Figure 21-47).
FIGURE 21-47 FIGURE 21-48
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
SOLENOID
RED/WHITE
WIRE
FORWARD AND REVERSE
ROCKER SWITCH
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
Z8 Z9 Z10 Z11 Z12 Z13
Z1
Z2 Z3 Z4 Z5 Z6 Z7
Z14
BLUE WIRE
PLACE RED PROBE
INTO THE Z7 POSITION
ON THE Z PLUG