Canon iR C2880 series, Руководство по обслуживанию

Страница: 78 / 610

Chapter 2
2-22
F-2-74
12) Plug the power cable (for outlet) into the outlet.
13) Turn ON the switch of the main power.
14) Enter the card number (1 through 2001) to use by selecting the following in service mode of host machine:
COPIER > FUNCTION > INSTALL > CARD
- Enter the smallest number among the cards used by user
- 1000 cards from the input number are usable
15) Turn OFF the power supply following the shutdown sequence.
16) Insert the usable card (that is registered to use) to check that it is standby state.
2.8.4 Installation Procedure in the imageWARE Accounting Manager (hereinafter referred to iWAM) Environment
0013-8497
/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1) Check to see that 'ID00000001 to ID00001000' have been created in '[Initial Settings / Registration] > [System Administration Settings] > [Department ID
management] > [Count Management]' (In the case of entering '1' as the first number in 'Service Mode > COPIER > FUNCTION > INSTALL > CARD')
2) Press [Reset] to exit from [Initial Settings / Registration].
3) Select: [Initial Settings / Registration] > [System Administration Settings] > [Network Settings] > [TCP/IP Settings] > [IP Address], and make settings of [IP
Address], [Gateway Address], and [Subnet Mask] suitable for the user's environment.
4) Press [Reset] to exit from [Initial Settings / Registration].
5)
Be sure that without selecting: [Initial Settings / Registration] > [System Administration Settings] > [System Administrator Information Settings] and then regis-
tering [System Administration Department ID] and [System Administration Password], 'Card Registration to the Device' cannot be executed in the iWAM settings.
Select: [Initial Settings / Registration] > [System Administration Settings] > [System Administrator Information Settings], and then enter given numbers for
[System Administration Department ID] and [System Administration Password].
6) Press [Reset] to exit from [Initial Settings / Registration].
7) Turn OFF the power supply following the shutdown sequence.
[1]
[3] [4]
[2]