Canon iR C2880 series, Руководство по обслуживанию

Страница: 531 / 610

Chapter 17
17-47
17.6 OPTION (Machine Settings Mode)
17.6.1 COPIER
17.6.1.1 COPIER Table
0014-6028
/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1. BODY
T-17-54
SL-ON Use it to start the operation of the selected solenoid.
Operation
The operation varies from model to model.
1) Press [SL] to highlight; then, press the OK key to start motor operation.
2) Press the OK key once again to stop the ongoing operation.
(The operation will stop automatically in 5 sec; however, the indication will not change to [STOP] unless the OK key is
pressed once again.)
1
MTR-ON Use it to start motor operation.
Operation
The operation varies from model to model.
1) Press [MTR-ON] to highlight; then, press the OK key to start motor operation.
2) Press the OK key once again to stop the motor.
(The operation will stop automatically in 5 sec; however, the indication will not change to [STOP] unless the OK key is
pressed once again.)
1
ROLL-CLN Use it to clean the ADF roller.
In this mode item, the roller is rotated by the work of its motor; it is cleaned by lint-free paper (moistened with alcohol)
forced against it while it rotates.
Operation
1) Press [ROLL-CLN] to highlight.
2) While the roller is rotating, clean it by forcing lint-free paper (moistened with alcohol) against it.
3) Press [ROLL-CLN] to highlight, and press the OK key to stop the rotation of the roller.
1
FEED-ON Use it to check the movement of paper in the ADF on its own.
Operation
1) Press [FEED-ON], and then press the OK key so that the ADF starts to move paper according to the operation mode
selected using [FEED-CHK]. 1
COPIER>OPTION>BODY
Sub item Description level.
MODEL-SZ Used to select standard variable magnification display and ADF document size detection.
Caution!
The setting value takes effect after the main power switch is turned OFF/ON.
Setting values
0: AB (6R5E)
1: INCH (5R4E)
2: A (3R3E)
3: AB/INCH (6R5E)
1
PASCAL Used to select whether to use the contrast electric potential calculated by automatic gradation compensation (full
compensation) control, and the gradation compensation data.
Caution!
- For printer models, you must always make this setting value 0 at time of installation.
- The setting value takes effect after the power switch is turned OFF/ON.
Setting values
0: Don't use
1: Use
[Factory default/After RAM clear: 1]
1
CONFIG This selects the multiple firmware programs held on the hard disk, and selects the unit's country, language, destination
and sheet size series.
Attention:
The settings take effect after the main power switch has been set to OFF and then back to ON.
Operating procedure
1) Set the unit to the service mode, and select COPIER>OPTION>BODY>CONFIG.
2) Select the items to be selected, and press the "+" and "-" keys.
3) Each time the "+" and "-" key is pressed, the content changes.
4) Display the desired contents, and press the OK key.
5) Set the main power switch to OFF and then back to ON.
Settings: XXYYZZAA
XX: Country (example: JP -> Japan)
YY (*): Language (example: ja -> Japanese)
ZZ (*): Destination (example: 00 -> Canon)
AA: Sheet size series (example: 00 -> AB series)
*: This setting cannot be changed.
1
FEEDER>FUNCTION
Sub item Description level.