Cabletron Systems CSMIM-T1, Руководство администратора, Страница: 388 / 418

Chapter 19 Annex Parameters
19-88 CSMIM/Micro-CS Management Application Guide
slip_subnet_mask
contains the Annex’s IP subnet mask for a SLIP interface. The parameter’s
default is based on the network portion of the Annex’s IP address. Setting
this parameter incorrectly can cause routing problems.
slip_tos
allows an Annex to send interactive traffic (such as
telnet
,
rlogin
, and
ftp
control
sessions) before it sends other traffic. This parameter provides a
type-of-service based SLIP queuing.
speed
defines the baud rate of the asynchronous line between a device and an
Annex. The value you enter must match the device’s baud rate. If you want
line speed to be determined automatically, use the
autobaud
parameter.
If you enter
disabled
in the autobaud parameter, you must
enter a value here.
Not all Annexes support all port speeds. Please refer to your
Annex hardware guides for detailed information.
stop_bits
specifies the number of stop bits for a port.
Type Async
Values IP address
Default 0.0.0.0
Lists
Async Port, SLIP
Type Async
Values enabled or disabled
Default disabled
Lists Async Port, SLIP
Type Async
Values
2000, 2400, 3600, 4800, 7200, 9600, 19200, 38400, 57600,
115,200, and others
Default 9600
Lists Async Port, Basic Async Port, Modem
Type Async
Values one, two, one-and-half, dynamic
Default one
Lists Async Port, Basic Async Port, Modem, Modem Internal