Cabletron Systems CSMIM-T1, Руководство администратора, Страница: 136 / 418

Chapter 8 Setting ISDN Primary Rate Annex Values
8-12 CSMIM/Micro-CS Management Application Guide
in the United States,
ETS
for European lines, and
ETS-AUS
for
Australian lines.
❑
Other
displays as selected if the Annex you chose is operating
outside the United States. This setting indicates that the switch
type is set to
ETS
or
ETS-AUS
. You can use CLI admin commands
to check these values.
The
FDL Type
box allows you to configure the FDL standard. It describes
the facilities data link use. This allows the telephone company to read the
statistics maintained by an Annex and to perform diagnostic tests. There
are four choices:
❑
none
❑
att
❑
ansi
❑
Other
The
Buildout
box allows adjustment of the cable loss measurement between
the last T1 signal regenerator and your location. This measurement is
supplied by the telephone company at installation. You need to adjust your
buildout based on this measurement.There are four choices:
❑
odb
❑
7.5db
❑
15db
❑
20.5db
Using Push Buttons
This window uses , , , and buttons. For
detailed information about push buttons, see .
Setting the Switch Type
Setting the Type
To set a switch type
1 Select a single ISDN Primary Rate Annex in the main window.
2 Display the
T1/PRI Line
window.
Apply Restore Help Close