Bosch Rexroth VFC 3210, Руководство по эксплуатации, Страница: 111 / 282

12.2.3 Digital Output Configuration
Please read through the information on 'Wiring diagram' and 'Terminals' before
configuration of 'Digital output', see chapter 8.1 "Wiring Diagram" on page 31
and chapter "Digital outputs" on page 40 respectively.
Code Name Setting range Default Min. Attri.
E2.15 Relay 1 output selection 0...25 1 – Stop
E2.20
DO1/relay1 output values
from extension card fieldbus
communication
Bit8:
0 (Tb_Ta is opened)
1 (Tb_Ta is closed)
0 – Run
●
0: Converter ready
After powering on, if no error occurs and there is no run command or output
active indication, the frequency converter is ready for running.
●
1: Converter running
The output is active when the frequency converter is running and has fre-
quency output (including 0.00 Hz).
●
2: Converter DC-braking
The output is active when the frequency converter is in Start- or Stop- DC
braking, see chapter "DC-braking before start" on page 112 and chapter "DC-
braking during deceleration to stop" on page 117 .
●
3: Converter running at zero speed
The output is active when the frequency converter is running at zero speed.
There is no output for this selection during dead zone time of rota-
tion direction change.
●
4: Speed arrival
See
chapter 12.7.2 "Frequency Arrival" on page 129 .
●
5: Frequency level detection signal (FDT1)
●
6: Frequency level detection signal (FDT2)
See chapter 12.7.3 "Frequency Level Detection" on page 130 .
●
7: Simple PLC stage complete; 8: Simple PLC cycle complete
See chapter 12.8.4 "Stop and Pause Simple PLC Control" on page 136 .
●
10: Converter undervoltage
The output is active when DC-bus voltage is lower than 190 VDC (1P 200 VAC
models) / 380 VDC (3P 400 VAC models). The output will be inactive when
DC-bus voltage resumes and becomes stable.
In addition, this digital output will be activated by any soft start error.
VFC 3210 Bosch Rexroth AG
Functions and Parameters
DOK-RCON04-VFC3210****-IT01-EN-P
83/253