Baxi PBS-i WH2 Series, Руководство пользователя, Страница: 121 / 180

Parameter Description Factory setting
EHC–04
Factory setting
SCB-04
AP080 Outside temperature below which the antifreeze protection is
activated:
can be set from -29 to 20 °C
set to -30 °C = function deactivated
3 3
AP091 Outdoor sensor type
0 =Auto
0 -
AP098 Blocking input 1 contact direction configuration
0 = input active on Open contact
1 = input active on Closed contact
1 not available
AP099 Blocking input 2 contact direction configuration
0 = input active on Open contact
1 = input active on Closed contact
1 not available
AP100 Blocking input 2 setting
1 = Full blocking of the installation – frost protection not guaran­
teed
2 = Partial blocking of the installation – frost protection active
3 =User reset locking
4 =Backup Relieved
5 =Heat Pump Relieved
6 =HP & backup relieved
7 =High, Low Tariff
8 =Photovoltaic HP Only
9 =PV HP And backup
10 =Smart Grid ready
11 =Heating Cooling
2 not available
HP : Heat-pump Parameters = Heat pump parameters
Tab.50
Parameter Description Factory setting
EHC–04
HP000 Outside bivalent temperature
Outside bivalent temperature above which back up are not allowed to operate
10
HP054 COP threshold above which heat pump is authorized to operate when hybrid
mode is primary energy
Can be set from 1 to 5 °C
Value accepted when HP061=2
2.5
HP061 Hybrid mode management:
0 =No Hybrid
1 =Hybrid Cost
2 =Primary Energy
3 =Hybrid CO2
1
HP065 Electrical CO2 emission in heating mode
Can be set from 0 to 100 (x0.01)
Value accepted when HP061=3
18
HP066 Electrical CO2 emission in DHW mode
Can be set from 0 to 100 (x0.01)
Value accepted when HP061=3
4
HP067 Gas or Oil CO2 emission
Can be set from 0 to 100 (x0.01)
Value accepted when HP061=3
23
HP068 Boiler in appliance efficiency
Can be set from 0 to 100%
100
PP015 Central heating pump post run time
Post-circulation of the heating pump:
can be set from 0 to 98 minutes
set to 99 = runs continuously
3
9 Settings
7706696 - v04 - 11102018 AWHP-2 PBS-i 73