Baldor VS1SD, Инструкция по установке и эксплуатации

Страница: 71 / 192

Using the Keypad 6-13 MN766
6.9 Diagnostics
From the Menu display screen, select Diagnostics and press enter. These are read only values with the exception of the real
time clock settings.
See Chapter 9 for a more detailed description.
Action Description Display Comments
Press Menu. Displays top level menu options.
STATUS
BASIC PARAMS
ADVANCED PROG
EVENT LOG
DIAGNOSTICS
STATUS BACK
Press or to move cursor over
the “DIAGNOSTICS” selection.
Press to display next
group.
Displays active operating mode
settings.
STATUS 0.00r MAIN
OPERATING MODE
Keypad
Speed
AC Servo
DIAG
STOP LOCAL
Press to display next
group. Bit display of digital inputs,
outputs and the voltage present at
the internal 24V supply terminals.
STATUS 0.00r MAIN
DIGITAL I/O
INPUTS 100000000
OUTPUTS 0001
USER 24V 24.9V
DIAG
STOP LOCAL
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
Press to display next
group.
Output Frequency, % Feedforward
% Setpoint, % Feedback
STATUS 0.00r MAIN
PROC CONTROL PID
0.00HZ 0.0FF
0.0SP 0.0FB
DIAG
STOP LOCAL
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
Note: This screen does not appear
unless P1401 is set to
Displays software version, hp,
volts and Amp/Volt ratings.
STATUS 0.00r MAIN
SHH-1.21
RATED HP 3HP
RATED VOLTS 240.0V
RATED A/V 4.0A/V
DIAG
STOP LOCAL
Press to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
Press to display next
group.
STATUS 0.00r MAIN
RATED CURRE 9.6A
RATED PK CU 16.8A
DIAG
STOP LOCAL
Press to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
Press to display next
group.
Displays:
Power Base ID number
EE Firmware version
FPGA Firmware version
STATUS 0.00r MAIN
POWER BASE VERSION
ID 0x000A2003
EE VER 0x00000001
FPGA VER 0x00000A02
DIAG
STOP LOCAL
Press to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
0x=Hexadecimal
0b=Binary
Press to display next
group.
Displays real time clock values
(date and time) and total run time
since installation.
Press ENTER to set date and
time.
STATUS 0.00r MAIN
REAL TIME CLOCK
Jul 4, 2006
22:07:35
RUN TIMER 474.1HR
DIAG
STOP LOCAL
Press to go to the next or
previous Diagnostic screen.
Press F2 to return to main menu.
or
or
or
or
Note: Example display shows that
the drive enable terminal
(J2-8) is on and that
Relay Out 2 is on.
SHH-1.21
Press Enter to view diagnostic
information.
Press to display next
group.
Process Control.
Press F1 to go to STATUS screen.
Press F1 to go to STATUS screen.
Press F1 to go to STATUS screen.
Press F1 to go to STATUS screen.
Press F1 to go to STATUS screen.
Press F1 to go to STATUS screen.