Baldor VS1SD, Инструкция по установке и эксплуатации

Страница: 115 / 192

Troubleshooting 9-1 MN766
Chapter 9
Troubleshooting
The VS1SD continuously monitors its status and operation. When a fault occurs, the event and drive status is captured to
help you troubleshoot problems. The following are designed to help in troubleshooting:
• LEDs on the keypad indicate status (Stop, FWD, REV, Jog)
• Fault Codes displayed on the keypad display as they occur
• A log of these faults and the time each occurred is kept in the Event Log
• A trace log for each event stored in the Event log
9.1 Event Log
From the Menu display screen, select Event Log and press enter. If an error is displayed during operation, press the “Help”
key to learn more about the error. If more than one error was logged, access the Event Log and examine each error Entry at
the time of the event to learn more about the error.
Action Description Display Comments
Status Display After power up the display shows
the Status screen.
STATUS
FWD LOCAL
DIAG 600r MAIN
159.5V 600RPM
6.2A 20.00HZ
Press Menu Displays top level menu options.
STATUS
BASIC PARAMS
ADVANCED PROG
EVENT LOG
DIAGNOSTICS
DIAG BACK
Press to move cursor over
the “EVENT LOG” selection.
Press Enter to view the event log.
Event Log Display
LOW INITIAL BUS
0
Date Time
Entry #
0-9
HH:MM:SS
Displays error name,
Entry # and time the
error occurred.
DD/MM/YY
EV. LOG
STATUS TRACE
LOW INITIAL BUS
0 4-Jul-06 09:35:00
LOCAL STOP
Press to view next entry.
Press F2 to display Trace menu.
Press F1 to return to Status menu.
or
or
Trace
Input states, Output states, various voltage and current values etc. can be viewed to help understand the cause of the fault
condition. Each event in the Event log has its own Fault Trace displays that were captured when that event occurred. Scroll
through the event log to the event you wish to investigate.
Trace Displays
Action Description Display Comments
Event Log Display Press to scroll to the
event you want to investigate.
EV. LOG
STATUS TRACE
LOW INITIAL BUS
3
4-Jul-06 09:42:00
LOCAL
STOP
Press F2 (or press Enter) to show
the fault Trace for the event.
Fault Trace Display The Fault Latch word is displayed.
0x=Hexadecimal
0b=Binary
STATUS T0003 BACK
FAULT LATCH
0x0000
EV. LOG
FAULT TRACE
Press to view next entry.
This is a hex value.
The T0003 indicates the Fault
Trace for event 3 of the event log
is displayed.
or
or