Baldor VS1SD, Инструкция по установке и эксплуатации

Страница: 138 / 192

10-10 PLC Mode Description MN766
10.7 PLC Mode as Process PID Mode
This example shows how the PLC Mode rendered as the Process PID Mode.
Initialization:
Parameter Value Comment
P1401 PLC PLC operating mode selected
PLC Mode confi guration parameters:
Parameter
Number
Parameter Dec
Value
Byte 3 Condition Byte 2 Logic Byte 1 Condition Byte 0 Action
P3401 050.000.000.020 Input 1 (50) OR (0) False (0) Forward (20)
P3402 051.000.000.021 Input 2 (51) OR (0) False (0) Reverse (21)
P3403 001.000.000.034 True (1) OR (0) False (0) Param Table Select (34)
P3404 052.000.000.035 Input 3 (52) OR (0) False (0) Table Select Bit 0 (35)
P3405 053.000.000.038 Input 4 (53) OR (0) False (0) Torque/Speed (38)
P3406 054.000.000.029 Input 5 (54) OR (0) False (0) PID (29)
P3407 055.000.000.018 Input 6 (55) OR (0) False (0) Jog Enable (18)
P3408 055.000.000.006 Input 6 (55) OR (0) False (0) Jog Forward (6)
P3409 056.000.000.023 Input 7 (56) OR (0) False (0) Reset (23)
P3410 057.003.000.019 Input 8 (57) NOR (3) False (0) Fault (19)
User Analog Return
Analog Input 1
Analog Ref. Power +
1
2
3
4
5
6
7
J1
Analog Input 2+
Analog Input 2-
Analog Output 1
Analog Output 2
Enable
J2
Digital Output 1 + (Collector)
Digital Output 1 - (Emitter)
Digital Output 2 + (Collector)
Digital Output 2 - (Emitter)
Enable
Forward Enable
Reverse Enable
Table Select
Speed/Torque
Process Mode Enable
Jog
External Trip
Fault Reset
Digital Input 1
Digital Input 2
Digital Input 3
Digital Input 4
Digital Input 5
Digital Input 6
Digital Input 7
Digital Input 8
8
17
9
10
11
12
13
14
15
16
18
19
20
*
*Note: Remove factory jumper from J2-8 and J3-24 before connecting switch at J2-8.
See recommended tightening torques in Table A-2.
See Figure 5-4 for
connection information.
The Parameter Dec Value column can be used when entering the PLC confi guration parameters at the keypad (parameters
are shown as decimal long values - byte3.byte2.byte1.byte0).
For this mode Enable is active.
The unconditional True statement P3403 enables parameter table select (Table 10-5 ) at all times.
The Fault action is programmed to trigger whenever digital input 8 goes low.