Avaya Media Gateway G350, Руководство по обслуживанию

Страница: 115 / 332

Avaya Communication Manager controlled maintenance
DID-TRK (Direct Inward Dial Trunk)
Maintenance of the Avaya G350 Media Gateway 115
June 2004
61446 FAIL Battery feed test failed. A loop current fault was detected. This is most
probably an incoming CO-line problem. This failure code is only reported
by the TN2139 Italian DID Media Module.
Check the incoming CO-line for loop current. If none is detected refer the
problem to the CO.
If the CO-line checks out OK, the failure must be on the DID port. Replace
the Media Module.
61456 FAIL Battery feed test failed. An on-board problem was detected. This port is out-
of-service.
Replace Media Module.
61472 FAIL Battery feed test failed. A problem with the incoming CO-line was detected.
Check the incoming CO-line for proper operation. If warranted, refer the
problem to the CO.
If the CO-line is not at fault, the failure must be on the DID port. Replace
the Media Module.
PASS Current flow was detected for this port.
User-reported troubles on this port should be investigated using other port
tests and by examining connections.
Refer problem to the CO.
Any NO
BOARD The test could not relate the internal ID to the port (no board).
Check to ensure that the board translations are correct. Translate the board,
if necessary.
Use the busyout board command.
Use the
reset board
command.
Use the release busy board command.
Use the
test board
command. This should re-establish the linkage
between the internal ID and the port.
If the problem persists, replace the circuit pack.
Table 59: TEST #35 Port Diagnostic Test 2 of 2
Error
Code Test
Result
Description/ Recommendation
2 of 2