ABB IRB 2600ID, Руководство по эксплуатации продукта

Страница: 115 / 466

3 Maintenance
3.1 Introduction
Structure of this chapter
This chapter describes all the maintenance activities recommended for the IRB
2600/IRB 2600 ID.
It is based on the maintenance schedule found at the beginning of the chapter.
The schedule contains information about required maintenance activities including
intervals, and refers to procedures for the activities.
Each procedure contains all the information required to perform the activity,
including required tools and materials.
The procedures are gathered in different sections and divided according to the
maintenance activity.
Safety information
Observe all safety information before conducting any service work.
There are general safety aspects that must be read through, as well as more specific
safety information that describes the danger and safety risks when performing the
procedures. Read the chapter
Safety on page 21 before performing any service
work.
The maintenance must be done by qualified personnel in accordance with the
safety requirements set forth in the applicable national and regional standards and
regulations.
Note
If the IRB 2600/IRB 2600 ID is connected to power, always make sure that the
IRB 2600/IRB 2600 ID is connected to protective earth and a residual current
device (RCD) before starting any maintenance work.
For more information see:
• Product manual - OmniCore V250XT
• Product manual - IRC5
• Product manual - IRC5 Panel Mounted Controller
• Robot cabling and connection points on page 104 .
Product manual - IRB 2600 115
3HAC035504-001 Revision: AD
© Copyright 2009-2023 ABB. All rights reserved.
3 Maintenance
3.1 Introduction