ACS550 User’s Manual
67
Start-Up
Group 01: Operating Data
This group contains drive operating data, including actual signals. The drive sets the
values for actual signals, based on measurements or calculations. You cannot set
these values.
Code Description
0102
SPEED
The calculated speed of the motor (rpm).
0103
OUTPUT FREQ
The frequency (Hz) applied to the motor. (Also shown by default in OUTPUT display.)
0104
CURRENT
The motor current, as measured by the ACS550. (Also shown by default in OUTPUT display.)
0105
TORQUE
Output torque. Calculated value of torque on motor shaft in % of motor nominal torque.
0106
POWER
The measured motor power in kW.
0107
DC BUS VOLTAGE
The DC bus voltage in VDC, as measured by the ACS550.
0109
OUTPUT VOLTAGE
The voltage applied to the motor.
0110
DRIVE TEMP
The temperature of the drive power transistors in Centigrade.
0111
EXTERNAL REF 1
External reference,
REF
1, in rpm or Hz – units determined by parameter 9904.
0112
EXTERNAL REF 2
External reference,
REF
2, in %.
0113
CTRL LOCATION
Active control location. Alternatives are:
0 =
LOCAL
1 =
EXT
1
2 =
EXT
2
0114
RUN TIME (R)
The drive’s accumulated running time in hours (h).
• Can be
reset
by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0115
KWH COUNTER (R)
The drive’s accumulated power consumption in kilowatt hours.
• Can be
reset
by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0116
APPL BLK OUTPUT
Application block output signal. Value is from either:
• PFC control, if PFC Control is active, or
• Parameter 0112
EXTERNAL
REF
2.
0118
DI1-3 STATUS
Status of the three digital inputs.
• Status is displayed as a binary number.
• 1 indicates that the input is activated.
• 0 indicates that the input is deactivated.
0119
DI4-6 STATUS
Status of the three digital inputs.
• See parameter 0118
DI
1-3
STATUS
.
0120
AI1
Relative value of analog input 1 in %.
DI
1
DI
2
DI
3
