Chapter 21 VPN 1-1 Mapping
UAG CLI Reference Guide
138
21.2.1 vpn-1-1-map pool Sub-commands
The following table describes the sub-commands for the vpn-1-1-map pool command.
21.2.2 vpn-1-1-map pool Command Examples
The following commands create a pool profile and display the settings.
21.2.3 vpn-1-1-map rule Sub-commands
The following table describes the sub-commands for several vpn-1-1-map rule commands. Note
that not all rule commands use all the sub-commands listed here.
Table 79
vpn-1-1-map pool Sub-commands
COMMAND
DESCRIPTION
address
address_object
Configures the name of the IP address object the profile is set to use.
An address object presents the IP address(es), which can be assigned
to the matched users by the UAG.
Note: You cannot configure an address group object at the time of
writing.
Note: It's recommended that the IP addresses of the configured
address object and the WAN interface are in the same subnet
so that the UAG can receive response packets from the remote
node.
exit
Leaves the sub-command mode.
interface
interface_name
Sets the interface through which the UAG sends traffic from the
matched users.
Router# configure terminal
Router(config)# vpn-1-1-map pool pool1
Router(vpn-1-1-map-pool-pool1)# address WAN-1
Router(vpn-1-1-map-pool-pool1)# interface wan1
Router(vpn-1-1-map-pool-pool1)# exit
Router(config)# show vpn-1-1-map pool
Pool: pool1
address: WAN-1
interface: wan1
Router(config)#
Table 80
vpn-1-1-map rule Sub-commands
COMMAND
DESCRIPTION
activate
Enables the VPN 1-1 mapping rule.
deactivate
Disables the VPN 1-1 mapping rule.
exit
Leaves the sub-command mode.
flush pool
Removes all pool profile(s) and resets the pool profile setting to the
default (
any
).
any
means all IP address.
Summary of Contents for UAG Series
