![background image](http://html.mh-extra.com/html/zyxel-communications/uag-series/uag-series_reference-manual_944300069.webp)
Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
69
7.5.1 Security Profile Example
The following example creates a security profile with the name ‘SECURITY01’..
wpa-encrypt {tkip | aes | auto}
Sets the WPA/WPA2 encryption cipher type.
auto
: This automatically chooses the best available cipher based
on the cipher in use by the wireless client that is attempting to
make a connection.
tkip
: This is the Temporal Key Integrity Protocol encryption
method added later to the WEP encryption protocol to further
secure. Not all wireless clients may support this.
aes
: This is the Advanced Encryption Standard encryption
method, a newer more robust algorithm than TKIP Not all
wireless clients may support this.
wpa-psk {
wpa_key | wpa_key_64
}
Sets the WPA/WPA2 pre-shared key.
[no] wpa2-preauth
Enables pre-authentication to allow wireless clients to switch APs
without having to re-authenticate their network connection. The
RADIUS server puts a temporary PMK Security Authorization
cache on the wireless clients. It contains their session ID and a
pre-authorized list of viable APs.
Use the
no
parameter to disable this.
[no] reauth <30..30000>
Sets the interval (in seconds) between authentication requests.
The default is 0.
idle <30..30000>
Sets the idle interval (in seconds) that a client can be idle before
authentication is discontinued.
The default is 300.
group-key <30..30000>
Sets the interval (in seconds) at which the AP updates the group
WPA/WPA2 encryption key.
The default is 1800.
[no] dot1x-eap
Enables 802.1x secure authentication. Use the
no
parameter to
disable it.
eap {external | internal
auth_method
}
Sets the 802.1x authentication method.
[no] server-auth
<1..2> activate
Activates server authentication. Use the
no
parameter to
deactivate.
server-auth <1..2> ip address
ipv4_address
port <1..65535> secret
secret
Sets the IPv4 address, port number and shared secret of the
RADIUS server to be used for authentication.
[no] server-auth <1..2>
Clears the server authentication setting.
exit
Exits configuration mode for this profile.
Table 21
Command Summary: Security Profile (continued)
COMMAND
DESCRIPTION
Router(config)# wlan-security-profile SECURITY01
Router(config-security-profile)# mode wpa2
Router(config-security-profile)# wpa-encrypt aes
Router(config-security-profile)# wpa-psk 12345678
Router(config-security-profile)# idle 3600
Router(config-security-profile)# reauth 1800
Router(config-security-profile)# group-key 1800
Router(config-security-profile)# exit
Router(config)#
Summary of Contents for UAG Series
