Chapter 10 Dynamic Channel Selection
UAG CLI Reference Guide
78
10.2.1 DCS Examples
This example creates a DCS configuration.
This example displays the DCS configuration created in the previous example.
dcs client-aware {enable|disable}
When enabled, this ensures that an AP will not change channels
as long as a client is connected to it. If disabled, the AP may
change channels regardless of whether it has clients connected to
it or not.
dcs channel-deployment {3-channel|4-channel}
Sets either a 3-channel deployment or a 4-channel deployment.
In a 3-channel deployment, the AP running the scan alternates
between the following channels: 1, 6, and 11.
In a 4-channel deployment, the AP running the scan alternates
between the following channels: 1, 4, 7, and 11 (FCC) or 1, 5, 9,
and 13 (ETSI).
Sets the option that is applicable to your region. (Channel
deployment may be regulated differently between countries and
locales.)
dcs dcs-2g-method {auto|manual}
Sets the AP to automatically search for available channels or
manually configures the channels the AP uses in the 2.4 GHz
band.
dcs dcs-5g-method {auto|manual}
Sets the AP to automatically search for available channels or
manually configures the channels the AP uses in the 5 GHz band.
dcs dfs-aware {enable|disable}
Enables this to allow an AP to avoid phase DFS channels below
the 5 GHz spectrum.
dcs invoke
Sets the managed APs to scan for and select an available channel
immediately.
dcs sensitivity-level {high| medium |low}
Sets how sensitive DCS is to radio channel changes in the vicinity
of the AP running the scan.
dcs time-interval
interval
Sets the interval that specifies how often DCS should run.
show dcs config
Displays the current DCS configuration.
Table 31
Command Summary: DCS (continued)
COMMAND
DESCRIPTION
Router(config)# dcs time-interval 720
Router(config)# dcs sensitivity-level high
Router(config)# dcs client-aware enable
Router(config)# dcs channel-deployment 3-channel
Router(config)# dcs dfs-aware enable
Router(config)# show dcs config
dcs activate: no
dcs time interval: 720
dcs sensitivity level: high
dcs client-aware: enable
dcs 2.4-ghz selection method: auto
dcs 2.4-ghz selected channels: none
dcs 2.4-ghz channel deployment: 3-channel
dcs 5-ghz selection method: auto
dcs 5-ghz selected channels: none
dcs 5-ghz DFS-aware: enable
Summary of Contents for UAG Series
