Chapter 17 Routing Protocol
UAG CLI Reference Guide
122
17.2.1 RIP Commands
This table lists the commands for RIP.
17.2.2 General OSPF Commands
This table lists the commands for general OSPF configuration.
Table 65
router Commands: RIP
COMMAND
DESCRIPTION
router rip
Enters sub-command mode.
[no] network
interface_name
Enables RIP on the specified Ethernet interface. The
no
command disables RIP on the specified interface.
[no] redistribute {static | ospf}
Enables redistribution of routing information learned from
the specified source. The
no
command disables
redistribution from the specified source.
redistribute {static | ospf} metric <0..16>
Sets the metric when redistributing routing information
learned from the specified source.
[no] version <1..2>
Sets the default RIP version for all interfaces with RIP
enabled. If the interface RIP version is blank, the interface
uses the default version. This is not available in the GUI.
The
no
command sets the default RIP version to 2.
[no] passive-interface
interface_name
Sets the direction to “In-Only” for the specified interface.
The
no
command sets the direction to bi-directional.
[no] authentication mode {md5 | text}
Sets the authentication mode for RIP. The
no
command
sets the authentication mode to “none”.
[no] authentication string
authkey
Sets the password for text authentication. The
no
command clears the password.
authentication key <1..255> key-string
authkey
Sets the MD5 ID and password for MD5 authentication.
no authentication key
Clears the MD5 ID and password.
[no] outonly-interface
interface_name
Sets the direction to “Out-Only” for the specified interface.
The
no
command sets the direction to “BiDir”.
Table 66
router Commands: General OSPF Configuration
COMMAND
DESCRIPTION
router ospf
Enters sub-command mode.
[no] redistribute {static | rip}
Enables redistribution of routing information learned from the
specified non-OSPF source. The
no
command disables redistribution
from the specified non-OSPF source.
[no] redistribute {static | rip} metric-
type <1..2> metric <0..16777214>
Sets the metric for routing information learned from the specified
non-OSPF source. The
no
command clears the metric.
[no] passive-interface
interface_name
Sets the direction to “In-Only” for the specified interface. The
no
command sets the direction to “BiDir”.
[no] router-id IP
Sets the 32-bit ID (in IP address format) of the UAG. The
no
command resets it to “default”, or the highest available IP address.
Summary of Contents for UAG Series
