Chapter 57 System Remote Management
UAG CLI Reference Guide
289
57.8.3 SNMP Commands
The following table describes the commands available for SNMP.
You must use the
configure
terminal
command to enter the configuration mode before you can use these commands.
57.8.4 SNMP Commands Examples
The following command sets a service control rule that allowed the computers with the IP
addresses matching the specified address object to access the specified zone using SNMP service.
Table 185
Command Summary: SNMP
COMMAND
DESCRIPTION
[no] snmp-server
Allows SNMP access to the UAG. The
no
command disables
SNMP access to the UAG.
[no] snmp-server community
community_string
{ro|rw}
Enters up to 64 characters to set the password for read-only
(ro) or read-write (rw) access. The
no
command resets the
password for read-only (
ro
) or read-write (
rw
) access to the
default.
[no] snmp-server contact
description
Sets the contact information (of up to 60 characters) for the
person in charge of the UAG. The
no
command removes the
contact information for the person in charge of the UAG.
[no] snmp-server enable {informs|traps}
Enables all SNMP notifications (informs or traps). The
no
command disables all SNMP notifications (informs or traps).
[no] snmp-server host {
w.x.y.z
}
[
community_string
]
Sets the IPv4 address of the host that receives the SNMP
notifications. The
no
command removes the host that receives
the SNMP notifications.
[no] snmp-server location
description
Sets the geographic location (of up to 60 characters) for the
UAG. The
no
command removes the geographic location for the
UAG.
[no] snmp-server port <1..65535>
Sets the SNMP service port number. The
no
command resets
the SNMP service port number to the factory default (
161
).
snmp-server rule {
rule_number
|append|insert
rule_number
} access-group {ALL|
address_object
}
zone {ALL|
zone_object
} action {accept|deny}
Sets a service control rule for SNMP service.
address_object
: The name of the IP address (group) object.
You may use 1-31 alphanumeric characters, underscores(
_
), or
dashes (-), but the first character cannot be a number. This
value is case-sensitive.
zone_object
: The name of the zone. Use up to 31 characters
(a-zA-Z0-9_-). The name cannot start with a number. This value
is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2,
SSL VPN, IPSec VPN, and WAN.
snmp-server rule move
rule_number
to
rule_number
Changes the index number of a service control rule.
no snmp-server rule
rule_number
Deletes a service control rule for SNMP service.
show snmp status
Displays SNMP Settings.
Router# configure terminal
Router(config)# snmp-server rule 11 access-group Example zone WAN action accept
Summary of Contents for UAG Series
