Chapter 6 AP Management
UAG CLI Reference Guide
56
The following table describes the commands available for AP management. You must use the
configure terminal
command to enter the configuration mode before you can use these
commands.
Table 13
Command Summary: AP Management
COMMAND
DESCRIPTION
capwap ap add
ap_mac
[
ap_model
]
Adds the specified AP to the UAG for management. If manual add
is disabled, this command can still be used; if you add an AP
before it connects to the network, then this command simply
preconfigures the management list with that AP’s information.
capwap ap fallback disable
Sets the managed AP(s) to not change back to associate with the
primary AP controller when the primary AP controller is available.
capwap ap fallback enable
Sets the managed AP(s) to change back to associate with the
primary AP controller as soon as the primary AP controller is
available.
capwap ap fallback interval <30..86400>
Sets how often (in seconds) the managed AP(s) check whether
the primary AP controller is available.
capwap ap kick {all |
ap_mac
}
Removes the specified AP (
ap_mac
) or all connected APs (
all
)
from the management list. Doing this removes the AP(s) from the
management list.
If the UAG is set to automatically add new APs to the AP
management list, then any kicked APs are added back to the
management list as soon as they reconnect.
capwap ap reboot
ap_mac
Forces the specified AP (
ap_mac
) to restart. Doing this severs the
connections of all associated stations.
capwap ap
ap_mac
Enters the sub-command mode for the specified AP.
slot_name
ap-profile
profile_name
Sets the radio (
slot_name
) to AP mode and assigns a created
profile to the radio.
no
slot_name
ap-profile
Removes the AP mode profile assignment for the specified radio
(
slot_name
).
slot_name
monitor-profile
profile_name
Sets the specified radio (
slot_name
) to monitor mode and
assigns a created profile to the radio. Monitor mode APs act as
wireless monitors, which can detect rogue APs and help you in
building a list of friendly ones. See also
no
slot_name
monitor-profile
Removes the monitor mode profile assignment for the specified
radio (
slot_name
).
description
ap_description
Sets the description for the specified AP.
[no] force vlan
Sets whether or not the UAG changes the AP’s management VLAN
to match the one you configure using the
vlan
sub-command.
The management VLAN on the UAG and AP must match for the
UAG to manage the AP.
vlan <1..4094> {tag | untag}
Sets the VLAN ID for the specified AP as well as whether packets
sent to and from that ID are tagged or untagged.
exit
Exits the sub-command mode for the specified AP.
capwap manual-add {enable | disable}
Allows the UAG to either automatically add new APs to the
network (
disable
) or wait until you manually confirm them
(
enable
).
capwap show statistic
Displays statistics about the wireless radio transmitters in each of
the APs connected to the UAG.
capwap station kick
sta_mac
Forcibly disconnects the specified station from the network.
lan-provision ap
ap_mac
Enters the sub-command mode for the specified AP.
Summary of Contents for UAG Series
