Chapter 58 File Manager
UAG CLI Reference Guide
301
Note: You only need to use the
atuk
or
atur
command if the recovery image is damaged.
Figure 32
atuk Command for Restoring the Recovery Image
4
Enter
Y
and wait for the “Starting XMODEM upload” message before activating XMODEM upload on
your terminal.
Figure 33
Starting Xmodem Upload
5
This is an example Xmodem configuration upload using HyperTerminal. Click
Transfer
, then
Send
File
to display the following screen.
Figure 34
Example Xmodem Upload
6
Wait for about three and a half minutes for the Xmodem upload to finish.
Figure 35
Recovery Image Upload Complete
> atuk
This command is for restoring the "recovery image" (xxx.ri).
Use This command only when
1) the console displays "Invalid Recovery Image" or
2) the console freezes at "Press any key to enter debug mode within 3 seconds"
for more than one minute.
Note:
Please exit this command immediately if you do not need to restore the
"recovery image".
Do you want to start the recovery process (Y/N)? (default N)
Do you want to start the recovery process (Y/N)? (default N)
Starting XMODEM upload (CRC mode) ....
C
Type the firmware file's
location, or click
Browse
to
search for it.
Choose the
1K Xmodem
protocol.
Then click
Send
.
Total 1067264 bytes received.
programming .......................................................................
....................................................................................
....................................................................................
....................................................................................
....................................................................................
....................................................................................
OK
>
Summary of Contents for UAG Series
