Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
62
[no] amsdu
Activates MPDU frame aggregation for this profile. Use the
no
parameter to disable it.
Mac Service Data Unit (MSDU) aggregation collects Ethernet
frames without any of their 802.11n headers and wraps the
header-less payload in a single 802.11n MAC header. This method
is useful for increasing bandwidth throughput. It is also more
efficient than A-MPDU except in environments that are prone to
high error rates.
By default this is enabled.
limit-amsdu <2290..4096>
Sets the maximum frame size to be aggregated.
The default is 4096.
[no] multicast-to-unicast
“Multicast to unicast” broadcasts wireless multicast traffic to all
wireless clients as unicast traffic to provide more reliable
transmission. The data rate changes dynamically based on the
application’s bandwidth requirements. Although unicast provides
more reliable transmission of the multicast traffic, it also
produces duplicate packets.
The
no
command turns multicast to unicast off to send wireless
multicast traffic at the rate you specify with the
2g-multicast-
speed
or
5g-multicast-speed
command.
[no] block-ack
Makes
block-ack
active or inactive. Use the
no
parameter to
disable it.
ch-width
wlan_htcw
Sets the channel width for this profile.
guard-interval
wlan_htgi
Sets the guard interval for this profile.
The default for this is
short
.
2g-basic-speed
wlan_2g_basic_speed
Sets the 2.4 GHz basic band rates.
The default is 1.0 2.0 5.5 11.0.
2g-channel
wireless_channel_2g
Sets the broadcast band for this profile in the 2.4 GHz frequency
range. The default is 6.
2g-mcs-speed {disable |
wlan_mcs_speed
}
Disables or sets the 2.4 GHz HT MCS rate.
The default is 0~15.
2g-multicast-speed
wlan_2g_support_speed
When you disable multicast to unicast, use this command to set
the data rate {
1.0 | 2.0 | …
} in Mbps for 2.4 GHz multicast
traffic.
2g-support-speed
{disable |
wlan_2g_support_speed
}
Disables or sets the 2.4 GHz support rate.
The default is 1.0~54.0.
5g-basic-speed
wlan_5g_basic_speed
Sets the 5 GHz basic band rate.
The default is 6.0 12.0 24.0.
5g-channel
wireless_channel_5g
Sets the broadcast band for this profile in the 5 GHz frequency
range. The default is 36.
5g-mcs-speed {disable |
wlan_mcs_speed
}
Disables or sets the 5 GHz HT MCS rate.
The default is 0~15.
5g-multicast-speed {
wlan_5g_basic_speed
}
When you disable multicast to unicast, use this command to set
the data rate {
6.0 | 9.0 | …
} in Mbps for 5 GHz multicast
traffic.
Table 15
Command Summary: Radio Profile (continued)
COMMAND
DESCRIPTION
Summary of Contents for UAG Series
