Zeiss OPMI Lumera i on floor stand, Instructions For Use Manual

Page: 69 / 178

OPMI Lumera
®
i on floor stand Preparations for use
Version 9.2
G-30-1720-en
Page 69
•
Remove the binocular tube (5).
•
Attach the new binocular tube to the microscope body, and firmly tighten
the securing screw (4).
•
You can install further accessories between the binocular tube and the
microscope body. Lock these components into position in the same way
using the securing screw (4).
•
Take the widefield eyepieces out of their seating on the binocular tube.
Because the eyepieces are magnetically held in place, it is necessary to
apply some force.
•
Insert the new widefield eyepieces (7) as far as they will go in the mounts
(6) intended for them. The magnetic coupling reliably secures them in
position.
•
Unscrew the objective lens (3) from the microscope body by turning it
counter-clockwise.
•
Turn the new objective lens into the threaded mount on the microscope
body as far as it will go.
•
Loosen the friction adjustment knob (1) again and perform a balancing
procedure.
After changing tubes, eyepieces, or the objective lens, you have to adjust the
relevant parameters in the “System Settings” menu to ensure that the total
magnification of the system is correctly displayed (see page 117).
Fig. 19: Changing tubes,
eyepieces, objective lens
1 2 3 4 5 6 7