Zeiss OPMI Lumera i on floor stand, Instructions For Use Manual

Page: 117 / 178

OPMI Lumera
®
i on floor stand Operation
Version 9.2
G-30-1720-en
Page 117
Setting parameters for overall magnification
To ensure correct display of the overall magnification, the parameters of the
objective lens used, the tube, and the eyepieces must be set. The settings are
applied for all users.
•
Select <System Settings> <System Options> <Optical settings> in the main
menu.

The “Optical settings” menu is displayed.
•
Select the system components used in the “Objective lens”, “Tube”,
and “Eyepieces” fields.
•
To save the changes, press the button.

The “System Options” menu is displayed again.
System information
The “Versions” submenu permits you to check the software currently installed
on your system.
•
Press <System Settings> <System Options> <Versions> in the main menu.

The “Versions” menu is displayed.

It contains information about the PC software
(PC-SW) and firmware (Light, OPMI, XY, Camera, Gateway, Foot
Panel) currently installed.
Pairing with wireless foot control panel
Pairing refers to the fixed relative assignment of the stand and the foot control
panel. Pairing must be performed for wireless operation.
NOTICE Foot control panel may be disabled!
•
If pairing is performed incorrectly or not at all, the foot control panel may
be disabled, or activation of a control element may trigger functions on
a different stand not assigned to the foot control panel.