Zeiss OPMI Lumera i on floor stand, Instructions For Use Manual

Page: 118 / 178

Operation OPMI Lumera
®
i on floor stand
Version 9.2
Page 118 G-30-1720-en
Performing pairing
•
Press <System Settings> <System Options> <Pairing> in the main menu.

The “Pairing” menu is displayed.
•
Put the foot control panel in its vertical position in the immediate vicinity
of the system (max. distance of 1 m) and keep it in this position until pair-
ing is finished.
•
Start the pairing process by pressing the <Start pairing> button on the
5.7
″ control panel.

The following message is displayed: “Pairing of system and foot con-
trol panel is in progress. Press a button of the foot control panel until
the third LED from the top is flashing yellow AND keep the foot control
panel in a vertical position.”
Successful pairing

If pairing was successful, the “Radio link intensity” status indicator (1)
flashes green for approx. 1 s, and the following message appears:
– “Pairing successfully completed. Bring the foot control panel in a hori-
zontal position (working position) and perform a function test. Set the
wheel of the foot control panel to the number indicated on the
suspension system.”
•
You can check whether pairing was successful by simultaneously pressing
any two buttons (2) on the foot control panel. The “Radio link intensity”
status indicator (1) then lights up.
Pairing failed

If pairing failed, the “Radio link intensity” status indicator (1) flashes red
for approx. 1 s, and one of the following messages appears:
– “Pairing could not be successfully completed. No foot control panel
detected.”
– “Pairing could not be successfully completed. Several foot control
panels detected.”
•
Repeat the pairing process as described above.
2
2
2
2
2
2
1