![background image](http://html1.mh-extra.com/html/zeiss/lattice-lightsheet-7/lattice-lightsheet-7_instructions-manual_3406249046.webp)
SAFETY INFORMATION
ZEISS
User Interface - Mounting and Dismounting Components
Lattice Lightsheet 7
46
000000-2324-960
04/2021 V_01
1.13.6.4
SW Control of Incubation
The Heating System and the Gas Mixer System are controlled via the ZEN SW in the
Incubation
Alternatively, ibidi’s Incu Control SW can be used.
Both allow to set the environmental parameters and to log the temperature and the gas concentration.
Fig. 26
ZEN SW control for incubation
Fig. 27
IncuControl SW for incubation
In the ZEN software, the following warning symbols are displayed:
For Temperature:
Actual Temperature corresponds to set temperature within a range within of ±0.1 °C
actual temperature is below set temperature
actual temperature is above set temperature
Temperature setting not active (unchecked box)
For Atmosphere:
Actual gas / humidity concentration corresponds to set concentration within a range within of ±0.1%
actual gas concentration does not correspond to set concentration
Temperature setting not active (unchecked box)
Sensor Temperature is only displayed if the sensor of the Temperature Adjustment set is plugged into
the corresponding socket of the Temperature controller (Fig. 19/
15
).