Yamaha MBK XMAX 2014, Service Manual

Page: 29 / 482

INSTRUMENT FUNCTIONS
1-20
push the “RESET” button for at least 3 sec-
onds. The oil change tripmeter value will
flash.
3. Hold the “RESET” button pushed for 15 to 20
seconds.
4. Release the “RESET” button, and the oil trip
value will reset to zero.
TIP
If the engine oil is changed before the oil change
indicator comes on (i.e. before the periodic oil
change interval has been reached), the indicator
must be reset after the oil change for the next
periodic oil change to be indicated at the correct
time. To reset the oil change indicator before the
periodic oil change interval has been reached,
follow the above procedure.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the key to “ON”.
2. Check that the oil change indicator comes on
for a few seconds and then goes off.
3. If the oil change indicator does not come on,
check the electrical circuit.
Refer to “SIGNALING SYSTEM” on page
8-23.
V-belt replacement indicator “V-Belt”
This indicator flashes every 18000 km (10500 mi
when the V-belt needs to be replaced.
After changing the V-belt, reset the V-belt re-
placement indicator.
[To reset the V-belt replacement indicator]
1. Turn the key to “ON”.
2. Push the “TRIP” button until “V-belt” (V-belt
replacement tripmeter) is displayed in the
odometer and trip meter display. While “V-
belt” is displayed, push the “RESET” button
for 3 seconds. The V-belt replacement trip-
meter value will flash.
3. Hold the “RESET” button pushed for 15 to 20
seconds.
4. Release the “RESET” button, and the V-belt
trip value will reset to zero.
TIP
If the V-belt is replaced before the indicator
comes on, be sure to reset the V-belt replace-
ment indicator so that it will come on at the next
correct interval.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. “TRIP/INFO” switch
2. “RESET” button
1. “RESET” button
Oil o d O
1 2
C
H
km
Air
l
i O o d O
km
l i O
1
C
H
Air
km
1. “TRIP/INFO” switch
2. “RESET” button
1. “RESET” button
Air
o d O
1 2
V-Belt
C
H
km
o d O
km
1
V-Belt
e B - V lt
C
H
km
Air