Xante Assel-a-Writer-8300, Instruction Manual

Page: 88 / 338

3-20 Macintosh Setup bb ____________________________________
6. Verify the setup.
a. Make sure your Macintosh is connected to the printer
with a LocalTalk or Ethernet cable.
b. Locate and open the XANTÉ Utilities folder; then,
double-click the XANTÉ Command Center icon.
c. Select Printer Status from the General menu to display a
dialog box showing the current printer status.
Note: If the status dialog box does not appear check all
cable connections and be sure the printer
interface you are using is enabled on the printer.
d. Click OK in the dialog box; then select Quit from the
File menu to close XANTÉ Command Center.
Downloads Folder
The Downloads folder contains Adobe PostScript files and
Overview.PDF, which describes these files. Download the PostScript
files to your printer using the Adobe Downloader or the Download
PostScript File option in XANTÉ Command Center (see “Adobe
Downloader” and “XANTÉ Command Center” later in this chapter).
The Clean.ps file prints cleaning instructions for the Accel-a-Writer
8100, 8200, and PlateMaker II.
The CT4_cal.ps file prints instructions for performing color
calibration of the CT4 from a Macintosh and a PC.
The Ftp.ps file prints instructions for uploading and downloading
files to XANTÉ’s FTP (File Transfer Protocol) site.
The InitdskX.ps files are used to initialize hard disks attached to or
installed in your printer.
• The numbered files initialize the SCSI disk with the same device
number (Initdsk1.ps initializes SCSI disk #1, Initdsk2.ps
initializes SCSI disk #2, etc.) on the printer.