Xante Assel-a-Writer-8300, Instruction Manual

Page: 46 / 338

2-22 Installation bb _________________________________________
12. Make certain the paper cassette cover is in place to prevent the
possibility of a paper jam (fig. 2.29). Then, slide the cassette
into the printer until it snaps in place.
13. Plug the printer’s power cord into the duplexer’s power
receptacle and into the power source. Then, turn the printer on.
Removing the Duplexer
1. Turn off the printer, disconnect the power cord from the power
supply and the duplexer.
2. Remove the paper cassette by pulling it straight out of the
printer.
3. Pull up the back cover release latch and slide the back unit
open as far as it will go; then, remove the back unit by pulling
up both the top and back cover latches, and lifting the unit
straight up (fig. 2.20).
Fig. 2.20 Remove the Back Unit
4. Disconnect the interface cables from the printer and lift them
out of the cable rest (fig. 2.18).
5. Remove the cable guide by lifting it up and gently pulling it
out of printer (fig. 2.17).
6. Disconnect the duplexer’s power cord from the printer (fig. 2.16).