Xante Assel-a-Writer-8300, Instruction Manual

Page: 164 / 338

4-48 PC Setup bb __________________________________________
Fig. 4.30 The X•ACT Screen
2. Select the media size from the Paper menu (Fig. 4.30).
3. Click Update/Print to print a page with a horizontal and a
vertical line on it. Click OK in the X•ACT message box.
4. Turn the test page so that the large and small crosses are
aligned with one another as they are on the X•ACT
Calibration screen (fig. 4.30).
5. Measure the horizontal line. Adjust the horizontal slide bar on
the X•ACT screen until the measured length of the line is
displayed to the right of the bar.
6. Measure the vertical line. Adjust the vertical slide bar on the
X•ACT screen until the measured length of the line is
displayed above the bar.
7. Click Update/Print. When the new page prints, measure the
lines. They should be the correct lengths. If not, repeat steps 5,
6, and 7 until the measurements are correct.
8. Click Close to return to the XANTÉ Command Center main
menu; then adjust the printer margins using the following
procedure.