Wesmar HD800/110-10, Installation & Operation Manual

Page: 61 / 100

Page 61
WESMAR
INSTALLATION AND OPERATION
Turn on the hoist power only. Console is off. Verify
the hoist down light on the console is on.
Touch terminal 27 with the blue wire labeled 27
(top limit switch). This will power the RAM Hoist
Motor and Raise the Soundome. The hoist will rise
to the "up" position and stop.
If the motor does not stop and runs continuously, the
soundome may be up against the fl ange. Remove
the blue wire labeled 27.
Loosen the top hoist clamp and slide the soundome
tube down enough so the hoist motor can continue
up and trigger the up limit switch and stop.
9.1.5 With the hoist in the up position, verify the
hoist down light on the console is off. If the light
is on, adjust the light switch located on the top of
the stainless steel angle iron on the hoist. Move the
switch bracket up or down until the light goes out.
9.1.6. If the bottom of soundome boot is 3.8 cm
(1.5 inches) above the base of the seachest, the
installation is complete.