WAGO I/O SYSTEM 750 750-671, Manual

Page: 229 / 256

Overview of Error Blink Codes • 229
Auxiliary Commands
WAGO-I/O-SYSTEM 750
I/O Modules
Bit number Default
Name
Dec. Hex.
Type
Target/Source Bit no.
Description
159 0x9F
160 0xA0
161 0xA1
162 0xA2
163 0xA3
164 0xA4
165 0xA5
166 0xA6
167 0xA7
FILT1 168 0xA8 FILT ZERO 0x00 Timer / Filter 1
FILT2 169 0xA9 FILT ZERO 0x00 Timer / Filter 2
FILT3 170 0xAA FILT ZERO 0x00 Timer / Filter 3
FILT4 171 0xAB FILT ZERO 0x00 Timer / Filter 4
0: The value for the
timer or filter is
equal to 0
FILT5 172 0xAC FILT ZERO 0x00 Timer / Filter 5
FILT6 173 0xAD FILT ZERO 0x00 Timer / Filter 6
FILT7 174 0xAE FILT ZERO 0x00 Timer / Filter 7
FILT8 175 0xAF FILT ZERO 0x00 Timer / Filter 8
1: The value for the
timer or filter is
not equal to 0
Module enable
0: The module is not enabled. When this bit
is reset during ongoing operation, the
power output stage is deactivated.
Enable 176 0xB0 DST/
SRC KBUS_CTRL1
_0 0x40
1: The module is enabled and can be started
when the corresponding return message
is also available in the status.
Drive Stop 2 inverted
This bit can be used to deactivate the drive
from the control system.
The acknowledgement is transmitted via
Stop_N_ACK bit. Stop1_N and Stop2_N are
always taken into account at that bit.
0: Current is supplied to the motor, but it is
at standstill. If the motor is still turning it
is put into standstill by the STOP
acceleration command. The motor cannot
be started-up.
Stop2_N 177 0xB1 DST/
SRC KBUS_CTRL1
_1 0x41
1: The drive may be started.