Valco Cincinnati VC3500, User Manual

Page: 142 / 241

VC3700 User’s Manual
Operation
Valco Cincinnati 55
2. At the first glue pattern delay field, enter the distance from the leading edge of product to the beginning of
the first glue pattern. This distance will be entered in either inches (01.00 = 1 inch) or millimeters depend-
ing on the setup of your control.
3. At the first glue pattern length field, enter the length of the glue pattern. This distance will be entered in
either inches (01.00 = 1 inch) or millimeters depending on the setup of your control.
Note! A minimum of 00.01" or 0001 mm must be entered for the delay setting to activate the
channel.
4. At the second glue pattern delay field, enter the distance from the end of the first glue pattern to the
beginning of the second glue pattern.
5. At the second glue pattern length field, enter the length of the second glue pattern.
6. Press the “PAGE DOWN” button to see pattern information for the next channel.
7. Repeat steps 1 through 6 for channel 2.
Specifying the Product Length
A non-zero value for the product length enables the jam detection and scanner lockout functions. The value entered
should be approximately 2 inches (50 mm) longer than the actual product. To specify the product length, follow
these steps:
1. Press the “CONFIG” button on the main screen. (The level-1 menu screen displays.)
2. Press the “PRD LENGTH” button. (The product-length screen displays.)
3. Using the numeric keypad, input the length of the product plus two inches (50 mm).
4. Press the “ENTER” button. (The “OK DONE” message displays.)
5. Press the “EXIT” button to return to the level-1 menu screen.