Valco Cincinnati VC3500, User Manual

Page: 131 / 241

Menus VC3700 User’s Manual
Valco Cincinnati
42
Level-5 Menu Screen
The level-5 menu screen (Figure 24) displays when the word “MORE” on the level-4 menu screen is pressed. The
small box with the numeral 5 indicates that this is the level-5 menu screen. The function of each button is as
follows:
EXIT —Pressing this button returns you to the level-4 menu screen.
MORE— Pressing this button advances you to the level-6 menu screen.
IN/METRIC —Pressing this button displays the inch/metric screen. When “inch mode” is selected, all linear
measurements are displayed and entered in inches, and pressure is displayed in pounds per square inch (psi). When
“metric mode” is selected, all linear measurements are displayed and entered in millimeters, and pressure is dis-
played in “bar.”
PIN —Pressing the “PIN” button displays the PIN-code screen. A four-digit PIN code may be entered in order to
restrict access to menus 3-6.
GLUE QC —Pressing this button displays the glue inspection setup screen.
The Inch/Metric Screen
The inch/metric screen (Figure 24) is used to specify either inches or millimeters. The function of each button is as
follows:
EXIT —Pressing this button returns you to the level-5 menu screen.
INCH MODE —Pressing this button sets the control to imperial (inch and psi) measurements.
METRIC MODE —Pressing this button sets the control to metric (mm and bar) measurements.
The PIN Code Screen
The PIN code screen (Figure 24) is used to specify a PIN code in order to restrict screens 3-6. The function of each
button is as follows:
EXIT —Pressing this button returns you to the level-5 menu screen.
NEW PIN —Pressing this button displays a 6-digit numeric keypad, which you use to enter a new
4-digit PIN code.
The Glue Inspection Setup Screen
The glue inspection setup screen (Figure 24) is used to specify the allowable tolerance for glue inspection pass/fail
decisions. The function of each button is as follows:
EXIT —Pressing this button returns you to the level-5 menu screen.
MARKER —Pressing this button displays the marker-edit screen.
FAIL NUMBER —Pressing this button increments the number of consecutive glue faults to cause a machine-stop
condition. If the machine-stop relay is not wired to the parent machine, this parameter should be set to zero.
GREEN, AMBER, RED —Pressing one of these buttons selects the allowable tolerance for glue inspection pass/
fail decisions.
Range-Select Button ( )—Pressing this button changes the tolerances of definitions for the “GREEN”, “AM-
BER”, and “RED” buttons.