Valco Cincinnati VC3500, User Manual

Page: 133 / 241

Valco Cincinnati 45
Initial Setup
Introduction
This section contains procedures for initial setup of the control. It may be helpful to refer to the flowcharts pro-
vided in the “Menus” section of this manual. The flowcharts are located as follows:
•
Primary menu screens—Figure 17 (Page 30)
•
Level-1 menu screen and associated screens—Figure 20 (Page 33)
•
Level-2 menu screen and associated screens—Figure 21 (Page 35)
•
Level-3 menu screen and associated screens—Figure 22 (Page 37)
•
Level-4 menu screen and associated screens—Figure 23 (Page 39)
•
Level-5 menu screen and associated screens—Figure 24 (Page 41)
Initial Setup
To conduct initial setup of the control, complete each of the following procedures.
Disable Glue Valves for All Channels
1. Place channel toggle switches in center position (“0”) to prevent gluing during setup procedure.
Specify Inches or Millimeters
1. Press the “CONFIG” button on the main screen. (The level-1 menu screen displays.)
2. Press the “MORE” button in the level-1 menu screen.
3. Press the MORE button in menu screens 2, 3 and 4. The level-5 menu screen displays.
4. Press the “IN/METRIC” button. The inch/metric screen displays.
5. Press either the “INCH MODE” button or the “METRIC MODE” button. (The arrow points toward the
mode that you have selected).
Note! When the “inch mode” is selected, all linear measurements are displayed and entered in inches, using
four digits— two of which are decimal places (example: 10.00 = 10 inches). Pressure is displayed in
pounds per square inch (psi). When the “metric mode” is selected, all linear measurements are
displayed and entered in millimeters, using four digits (example: 1000 = 1000 millimeters). Pressure
is displayed in “bar.”
Note! Small errors (0.04 or 1mm) will result in parameters when switching between inch and metric modes.
6. Press the “EXIT” button to return to the level-5 menu screen.