Valco Cincinnati VC3500, User Manual

Page: 97 / 241

Valco Cincinnati 5
Routing Low-Voltage Leads
When routing low-voltage leads, follow these guidelines:
• Do not route low-voltage leads in the same conduit as wires carrying a high-current load.
• Do not route low-voltage leads adjacent to, or across wires carrying a high-current load. If low-voltage
leads must cross or run parallel to wires carrying high current, keep the leads at least 6" (152 mm) from
high-current wires.
• Do not splice or solder leads.
• Trim leads to the required length. Leads should be only as long as necessary for installation.
• All wiring should be in conduits or wireways.
Connecting the Supply of Electrical Power
Electrical connections should be made only by experienced service per-
sonnel!
The control must be connected to a “clean” supply of electrical power. Use a dedicated circuit if possible—if a
dedicated circuit is not available, do
not connect the control to a circuit that supplies high-amperage equipment. Use
another circuit such as a lighting circuit.
General Wiring Guidelines
Electrical installation should be accomplished only by experienced service
personnel!