UINICS LV1000 Series, Instruction Manual

Page: 23 / 67

- 19 -
RST
Preset setting value Table 4
Initial setting Notes
A B C D E A B C D E
OUT1 (-) 9 9 9 9
OUT2 (-) 9 9 9 9
OUT3 (-) 9 9 9 9
OUT4 (-) 9 9 9 9
8 step preset setting value Table 5
Initial setting Notes
A B C D E A B C D E
ch 1 (-) 9 9 9 9
ch 2 (-) 9 9 9 9
ch 3 (-) 9 9 9 9
ch 4 (-) 9 9 9 9
ch 5 (-) 9 9 9 9
ch 6 (-) 9 9 9 9
ch 7 (-) 9 9 9 9
ch 8 (-) 9 9 9 9
Mode protect setting value Table 6
Initial setting Notes
A B C D E A B C D E
L － ｏ F F
About initialization
When a power on while is pushing down ,“ ”display, and it enters the state of the
initialization selection.
It initializes (” “) display when is pushed at this time, and it shihts to the
measurement operation.
is pushed it shihts to the measurement operation without initializing.
After the initialization, the set values will be as shown in Table 1, Table 2-A to D, and
Table 3 to 6. Moreover, the deflection data of zero poit adjustment is cleared to”0”.
＜Caution＞
1．Since an initialization changes all existing setting values to the initial setting
values, be sure to record all the setting values before an initialization.Please
initialize without fail, and set each mode, the linearization and the preset value, etc.
again when either of data ischanged in the analog adjustment mode.
2．When abnormalities occur in a display or a function suddenly from normal operation,
please carry out reset of operation first.(P.11 Reference)
Still, please initialize it when the upset condition is not repaired by the
above-mentioned. Please set each mode the scaling and the preset value, etc.
again after it initializes it.
ENT
！